Communicate with Supplier? Supplier
helen Ms. helen
What can I do for you?
Chat Now
Chat Now Contact Supplier

Botou Kaiyite Cold Bending Machinery Co.,Ltd.

Industry Information

Home > Industry Information > Cold Bending Machinery

Cold Bending Machinery


The cold Bending Machine is a new type of equipment used for processing steel arch supports in tunnels. It is a special processing equipment designed to adapt to the poor construction of the surrounding rock, which can change randomly with the surrounding rock. There are many issues to be aware of before using the cold bending machine as follows:
First of all, we must choose to level the table, put the machine steady, you can open the chassis feet so that the machine panel is easy to observe. Insert the plug on the hand-held sensor head into the socket on the panel and screw it tight. Next, plug one end of the power cord into the socket on the rear panel of the chassis and the other end into the power supply socket. Be sure to use a single-phase three-wire power supply. Then open the “POWER SW.” on the rear panel of the chassis, press the “SWITCHING” button on the panel, wait until the “WARM UP” green indicator is on, and the machine can work. Press and hold the SETTING BUTTON button to set the appropriate value, typically between 0.5-2.0 seconds. Then place the sensor head on the lid of the container. Press the start button on the handle. The “HEATING” red indicator light is on, indicating that the heating is on. The sensor head should not be removed. The “HEATING” red indicator light After the sensor is turned off, the sensor head is removed, and after the “WARM UP” green indicator is on or the internal buzzer sounds a short beep, the next container can be sealed. Check the sealing quality, according to different materials, diameters of the container and production efficiency, properly trim "SETTING BUTTON" button, making the best sealing quality.
Careful inspection before work makes the operation of the cold bending machine safer and more efficient.
Botou Kaiyite Cold Bending Machinery Co.,Ltd.
Business Type:Distributor/Wholesaler , Manufacturer , Service , Trade Company
Product Range:Tile Making Machinery , Steel Frame & Purlin Machines , Tile Making Machinery
Products/Service:Roofing Sheet Roll Forming Machine , Shutter Door Roll Forming Machine , Door Frame Roll Forming Machine , Floor Deck Roll Forming Machine , Stud And Track Roll Forming Machine , Purlin Roll Forming Machine
Certificate:ISO9001 , CE
Company Address:Industrial Zone botou city, Cangzhou, Hebei, China

Previous: Metal Door Frame Roll Forming Machine Next: Hydraulic bending machine

Send Inquiry



Mobile Phone:+8613166560788Contact me with Whatsapp

Address:Industrial Zone botou city,cangzhou city,hebei province,China, Cangzhou, Hebei

Mobile Site




About Us